Filter
Top Products
Adjustment tips for the operating menu
20
Adjustment tips for the operating menu
Selecting a channel – “CHAN“
Via the “CHAN” menu, you can switch between the channels in the frequency banks “FIX” and
“VAR”. The RF signal is deactivated while this adjustment is being made.
When changing to the setting mode of the “CHAN” menu, the current channel number appears
on the LC display panel. After approx. 1 second, the currently assigned transmission frequency
is displayed:
̈ To select a different channel, slide the multi-function switch ¾ to the position ̆ (UP) or
̄ (DOWN). The new channel number appears on the LC display panel for approx. 1 second
and then the currently assigned transmission frequency is displayed.
Only after the new setting has been stored (“STORED” has appeared on the LC display panel)
is the RF signal with the frequency of the selected channel activated.
Selecting the frequencies to be stored in the frequency bank
“VAR” – “TUNE”
Via the “TUNE” menu, you can freely select the frequencies to be stored in the frequency bank
“VAR” (variable bank). The RF signal is deactivated while this adjustment is being made.
When setting frequencies on the bodypack transmitter, please observe the following:
̈ Make sure that the desired frequencies are listed in the enclosed frequency table and
approved and legal in your country. If necessary, apply for an operating license.
For an overview of the frequencies and transmission powers, refer to the enclosed
supplement “Legal requirements for the use of radiomicrophones”.
When you have selected the frequency bank “FIX” and then select the “TUNE” menu, the
transmitter automatically switches to channel 01 of the frequency bank “VAR” and the
text “VAR” briefly appears on the LC display panel ¿.
1 sec.
CH
CH
CH
MHz