Filter
Top Products
22
What to do if...
... the volume is up but you
̈
There is no audio signal available. Check the transmitter
cannot hear anything: connection. Is the volume at the headphone socket
of your sound source sufficient?
̈Are you still within the transmitter’s range?
̈Is the receiver on the same frequency as the
transmitter?
... the sound is distorted: ̈The receiver accupack has gone flat, please
recharge it immediately.
̈The volume on the receiver is adjusted too high.
Reduce the volume.
... the sound is slightly noisy: ̈You are about to leave the transmitter’s maximum
range. Soon transmission will be interrupted
completely.
̈The transmitter’s modulation level is too low.
Increase the volume on your sound source.
... you can hear twittering and ̈Two transmitters are interfering!
chirping, and the sound is “squeezed”: Choose a different transmission channel.
... the transmitter switches off ̈The volume on your TV set is adjusted too low. Adjust
during operation: the volume on the TV set such that the LED on the
transmitter blinks occasionally.
RS 2400_512759_0106_Sp6.book Seite 22 Mittwoch, 15. Februar 2006 8:34 08