Filter
Top Products
Using the devices
19
The lock mode icon ቪ of the transmitter or the lock mode icon ቦ of the diversity receiver
flashes prior to the lock mode being activated again.
Adjusting the audio channels on the transmitter
Via the “Mode” menu item, you can adjust the audio channels.
̈ Select “Stereo” if you want to transmit two separate audio signals on channel I and
channel II (e.g. channel I = audio signal of the presenter/musician, channel II = sum of all
audio signals). Make sure that the receiver’s pilot tone evaluation (“Pilot Tone” menu
item) is activated.
This allows the presenter/musician to adjust the balance between the left and right stereo
signal on his receiver.
̈ Select “Mono” if you only want to transmit a mono audio signal. In this case, the signal
from the left audio input BAL AF IN L ƺ is transmitted.
Activating/deactivating the RF signal on the transmitter
To deactivate the RF signal:
To activate the RF signal:
During mono operation, you have to deactivate the pilot tone evaluation on the
diversity receiver (“Pilot Tone” menu item) in order to ensure that your receiver
outputs the same signal on channel I and II.
̈ When the standard display is shown on the display panel, press the STANDBY
button.
“RF Mute On?” appears on the display panel.
̈ Press the jog dial.
The RF signal is deactivated. The transmission icon
ቦ
is not displayed. In
addition, the display backlighting changes from orange to red and “RF Mute”
flashes in alternation with the standard display.
̈ Press the STANDBY button.
“RF Mute Off?” appears on the display panel.
̈ Press the jog dial.
The RF signal is activated and the display backlighting changes from red to
orange.
You can also deactivate the RF signal on switch-on. For more information, refer to
the chapter “Switching the devices on/off” on page 16“.
519.150
ew300IEM
B.Ch: 1. 1
EQ
Standard -18dB
MHz
ቪ
MHz
519.150
ew300 IEM
AFRF
MUTE
P