Filter
Top Products
Putting the devices into operation
9
Putting the devices into operation
Putting the SR 300 IEM G3 transmitter into operation
Setting up the transmitter on a flat surface
Place the transmitter on a flat, horizontal surface. Please note that the device feet can leave
stains on delicate surfaces.
Mounting the rack
mount “ears”
To fasten the rack mount “ears” :
̈ Unscrew and remove the two recessed head screws (M4x8) on each side of the
transmitter.
̈ Secure the rack mount “ears” to the sides of the transmitter using the previously
removed recessed head screws.
Fitting the device feet
̈ Clean the base of the transmitter where you want to fix the device feet.
̈ Fit the device feet to the four corners of the transmitter.
Connecting the
rod antenna
The supplied rod antenna ƽ is suitable for use in good reception conditions.
̈ Connect the rod antenna ƽ to the BNC socket Ƽ.
When using more than one transmitter, we recommend connecting remote
antennas and, if necessary, using Sennheiser antenna accessories. Fore more
information, visit the ew G3 product page at www.sennheiser.com.
The rack mount “ears” are designed to help protect the operating elements from
damage or deformation, e.g. if the transmitter is dropped. Therefore, fasten the rack
mount “ears”, even if you do not want to rack mount your transmitter.
Do not fit the device feet when mounting the transmitter into a 19” rack.
ƽ
Ƽ