Filter
Top Products
25
22. Press and release the Select button to confirm the alarm
setup setting. The alarm setup setting is stored in the radio.
23. The display will show “Alarm saved” and will appear alarm symbol
indicating the alarm is set.
24. Pres the Tuning Up or Down buttons to select Off. The display will
show “Alarm saved” but the display will not appear alarm symbol.
Note:
If the above alarm setting procedures are not completed, the display
will show “Alarm Not saved“. You may have to start over above
procedures again.
25. The alarm has now been set and the unit will revert to the
previous display. The alarm symbol indicator (alarm 1 or 2) will
show on the display.
Note:
You can also press and hold down the Alarm button to switch the
“Alarm 1 Setup” or the “Alarm 2 Setup” menu, when your clock radio is
in Standby mode. Then press and release the Select button to enter the
“Alarm 1 Wizard“ or “Alarm 2 Wizard“ menu as above described.