Filter
Top Products
11
ENG
● CONNECTIONS
CONNECTING THE WIRELESS SUBWOOFER
The Subwoofer's linking ID is preset at the factory and the main unit and subwoofer should link (connect wirelessly)
automatically when the main unit and subwoofer are turned on. If the LINK indicator does not light when the main
unit and subwoofer are turned on, please set the ID by following the procedure below. Complete this process within
30 seconds after the Link Indicator on the subwoofer starts blinking.
1. Plug the power cords of the main unit and subwoofer into an AC wall outlet.
2. Confirm that the main unit is off (in STANDBY Mode).
3. Press the ID SET button on the back of the subwoofer with a small, pointed object for 5 seconds.
• The LINK INDICATOR (Blue LED) on the subwoofer blinks quickly.
4. While the main unit is powered off (in STANDBY mode), press and hold
the MUTE (
) on the remote control for 5 seconds.
5. The ID SET message appears on the main unit’s OLED display.
6. To finalize the link, turn the main unit’s power on while the subwoofer’s
LINK LED blinks.
• The main unit and the subwoofer should now be linked (connected).
• The LINK indicator (blue LED) on the subwoofer should be turned on
and solid blue.
• If the LINK indicator is not solid blue, the linking process has failed.
Turn off the main unit and start again from Step 2.
• You can enjoy better sound from the wireless subwoofer by selecting the a sound effect. (See page 24)
Before moving or installing the product, be sure to turn off the power and disconnect the power
cord.
If the main unit is powered off, the wireless subwoofer will be in the standby mode and the STANDBY
LED on the upper side will come on after the LINK indicator (Blue LED) blinks for 30 seconds.
If you use a device that uses the same frequency (2.4GHz) as the unit near the unit, interference
may cause some sound interruption.
The transmission distance of the wireless signal between the main unit and subwoofer is about
33 ft., but may vary depending on your operating environment. If a steel-concrete or metallic
wall is between the main unit and the wireless subwoofer, the system may not operate at all,
because the wireless signal cannot penetrate metal.
If the main unit doesn't make a wireless connection, follow steps 1-5 above to retry the
connection between the main unit and wireless subwoofer.
The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from
water and moisture.
For optimal listening performance, make sure that the area around the wireless subwoofer
location is clear of any obstructions.
TV
TV CH
S/W LEVEL
TONE
TV CH
S/W LEVEL
T
O
N
E
MUTE