Filter
Top Products
44 English
Setup
NOTE
Channel status displays are dependent on the
speaker confi guration.
SFE mode works with 2-ch signals.
If Dolby Pro Logic IIz is set to On, Dolby true
HD, Dolby plus, DTS-HD Master Audio, SFE
and NE0:6 will be output 5.1 channel.
DPL IIx
• Panorama : You can set it On or Off.
(This mode extends the front stereo image to
include the surround speakers for an exciting
"wraparound" effect with side wall imaging.)
• Dimension : You can set from -7 to +7.
(Incrementally adjusts the sound fi eld (DSP)from
the front or surround.)
• Center Width : You can set from 0 to 7.
(This sets the width of the center sound image.
The higher the setting, the less sound comes
from the center speaker.)
Extended Surround (EX/ES)
When surround back speakers are connected,
you can listen to 6.1 or 7.1 multi-channel sound
using the built-in Dolby Digital Surround EX or
DTS ES decoder. This function works when a
Dolby Digital or DTS source is input, and does
not work with L.PCM and Dolby Digital 2 channel
sources.
• Auto : If the unit receives an audio signal that it
can recognize, it will select an optimal decoder
for playback in 6.1/7.1 channels.
If the amplifi er does not recognize the audio
signal, it will not play in 6.1/7.1 channel
automatically.
✎
• Off : Dolby Digital Surround EX / DTS ES
decoder will not be used for playback.
• On : Dolby Digital or DTS signal will be played
in 6.1 / 7.1 channel using Dolby Digital
Surround EX / DTS ES decoder.
NOTE
You cannot use DTS-ES without surround
back speakers connected.
DTS Neo:6 Center Image
You can play back 2 channel sound over 6.1
channels when enjoying music or a movie.
You can set Center Image from 0 to 5.
This parameter adjusts the height of the center
image through the front and center speakers.
“0” is the lowest while “5” is the highest.
NOTE
NEO:6 mode cannot be used with Dolby
Digital, Dolly Digital Plus, Dolby True HD,
DTS, DTS-HD Master Audio.
Pro Logic works only for PCM audio signals
with sampling frequencies of 32KHz, 44KHz
or 48KHz.
Crossover Frequency
Select the crossover frequency for the best bass
response in your speakers.
You can set frequencies 60, 80, 100,120, 150,
180 or 200(Hz).
MP3 Enhancer
This also helps enhance your sound experience
(ex. mp3 music). You can upscale your MP3 level
sound (24 kHz, 8bit) to CD level sound (44.1 kHz,
16bit).
Smart Volume
This will regulate and stabilize the volume level
against a drastic volume change when changing
channels or during a scene transition.
✎
•
✎
•
HW-D7000_XAA_0321.indd 44HW-D7000_XAA_0321.indd 44 2011-03-21 2:01:572011-03-21 2:01:57