Filter
Top Products
26 English
Connections
Connecting to the Network
Wireless Network
You can connect to the network with a Wireless IP sharer.
A wireless AP/IP router is required to make a wireless network connection. Connect the wireless
LAN adapter to the Wireless LAN Adapter on the rear panel of the product.
Set the network options. (See page 37)
NOTE
This product is compatible with only Samsung's Wireless LAN Adapter. (not supplied) (Model name: WIS09ABGN).
- The Samsung Wireless LAN Adapter is sold separately. Contact a Samsung Electronics retailer for purchasing.
You must use a wireless IP sharer that supports IEEE 802.11 a/b/g/n. (n is recommended for stable operation of the
wireless network.)
Wireless LAN, by its nature, may cause interference, depending on the use condition (AP performance, distance, obstacles,
interference by other radio devices, etc).
Set the wireless IP sharer to Infrastructure mode. Ad-hoc mode is not supported.
When applying the security key for the AP (wireless IP sharer), only the following is supported.
Authentication Mode : WEP, WPAPSK, WPA2PSK
Encryption Type : WEP, TKIP, AES
For the AllShare function, a PC must be connected in the network as shown in the fi gure.
Connecting the FM Antenna
Connect the FM antenna supplied to the FM
75Ω COAXIAL Jack.
Slowly move the antenna wire around until you
fi nd a location where reception is good, then
fasten it to a wall or other rigid surface.
NOTE
This product does not receive AM broadcasts.
1.
2.
✎
1)
2)
1.
2.
✎
WI
iPod
W
I
i
Po
d
FM ANT
FM Antenna (supplied)
O
UT
I
OUT
COMPONENT OUT
VIDEO OUT
LAN
AUX IN
WIRELESS
LAN
I
OUT
COMPONENT OUT
V
IDE
O
OU
T
LAN
A
U
X IN
W
IRELE
SS
LAN
Wireless IP sharer
Wireless LAN Adapter
(not included)
Networking with PC for
AllShare function
(See pages 59~60)
PC
Broadband
service
HT-C5500_XAC_0129.indd 26HT-C5500_XAC_0129.indd 26 2010-01-29 3:24:282010-01-29 3:24:28