Filter
Top Products
Connect the AV receiver to a Samsung TV with an HDMI cable. (See page 15)
Set the Anynet+ function on your TV. (See the TV instruction manual for more information.)
• You can operate the AV receiver by using the TV remote control.
(Available TV button : VOLUME , button.)
1
2
16 17
ENG
1. Connect the FM antenna supplied to the FM 75Ω COAXIAL terminal as a temporary measure.
2. Slowly move the antenna wire around until you find a location where reception is good, then fasten it to a
wall or other rigid surface.
Connecting the FM antenna
FM antenna connection
FM antenna (supplied)
CONNECTIONS
Camcorder
Connecting AUX components
Connecting external devices
(Cont'd)
You can connect external devices you use (camcorder, game console, mobile equipment,etc.) to the front of this unit for
convenience.
Using Anynet+(HDMI-CEC)
Set the Anynet+(HDMI-CEC) function to <On> on your TV.
• Receiver : On : You can listen to audio through the AV Receiver.
• Receiver : Off : You can listen to audio through the TV.
Select THEATER to connector and set the option of each items below.
• View TV : If Anynet+(HDMI-CEC) set to on and you select View TV, the AV receiver will
automatically switch to SAT OPTIC2(DIGITAL IN).
• Receiver : On : You can listen to audio through the AV receiver.
• Receiver : Off : You can listen to audio through the TV.
1 Press SETUP/MENU button, and then press the ENTER button.
•
“SETUP MODE” appears on the display and goes into Setup Mode.
2 Press
œ √
button to select the “ANYNET+ MODE”, and then press the ENTER button.
3 Press the
…†
button to set ANYNET+ to OFF.
- If you are using Anynet+, set ANYNET+ to ON and if not, set it to OFF.
If you select TV
If you select the DVD Player
To turn off Anynet+
With Anynet+
You can operate this unit, power on your TV, or watch a movie by pressing the Play button on
your Samsung TV's remote control.
Anynet+
• When selecting View TV, you must have a digital optical cable connected
from the TV to the AV receiver to listen to the TV sound through the AV
receiver.
MOVE
ENTER
EXIT
MOVE
ENTER
EXIT
MOVE
ENTER
EXIT
To exit setup mode
•
Wait for about 5 seconds or press SETUP button.
“SETUP OFF” appears on the display and Setup Mode is exited.
•
When you are making Anynet+ connection, do not connect more than two AV receivers
(Anynet+ installed). Otherwise, it can cause a malfunction.
Caution
HT-AS720S-XAC-ENG 2008.1.25 3:16 PM Page 16