Filter
Top Products
27
ENG
26
OPERATION
Test tone
Use the test tone check the speaker connection status or level.
√
To automatically output test tone
Press SETUP/MENU button, and then press the ENTER
button.
•
“SETUP MODE” appears on the display and the unit goes into Setup Mode.
Press button to select the “TEST-T AUTO”,
and then press the ENTER button.
•
Test signal will be automatically output as follows; F.L ➝ CEN ➝ F.R ➝
S.R ➝ SBR ➝ SBL ➝ S.L ➝ S.W .
•
During test signal output, press …† button to adjust the individual speaker
output level from -10 to +10 dB by 1 step.
1
2
To stop test tone
•
Press SETUP/MENU button once time.
“SETUP OFF” appears on the display and test tone stops.
Press TEST TONE button.
•
Test signal will be automatically output as follows; F.L ➝ CEN ➝ F.R ➝ S.R ➝
SBR ➝ SBL ➝ S.L ➝ S.W.
•
During test tone output, press …† button to adjust the speaker output level from
-10 to +10 dB by 1 step.
Using the Test Tone button
√
To Manually Output Test Tone
•
F.L (front left) : -10 ~ +10dB
•
CEN (center) : -10 ~ +10dB
•
F.R (front right) : -10 ~ +10dB
•
S.R (surround right) : -10 ~ +10dB
•
SBR (surround back right) : -10 ~ +10dB
•
SBL (surround back left) : -10 ~ +10dB
•
S.L (surround left) : -10 ~ +10dB
•
S.W (subwoofer) : -10 ~ +10dB
Test Tone Output
Press SETUP/MENU button, and then press the ENTER
button.
•
“SETUP MODE” appears on the display and goes into Setup Mode.
Press
➛☎❿
button to select the “TEST-T MANU”, and then
press the ENTER button.
Press
➛☎❿
button to select the speaker you want..
•
Each time you press
➛☎❿☎
button, F.L ➝ CEN ➝ F.R ➝ S.R ➝ SBR ➝ SBL ➝
S.L ➝ S.W will be selected in turn.
Press …† button to set the test tone as you want.
•
You can adjust the speaker output level from -10 to +10dB by 1 step.
•
The sound gets quieter at -10dB and louder at +10dB.
1
2
3
4
To stop test tone
•
Press SETUP/MENU button once time.
“SETUP OFF” appears on the display and test tone stops.
HT-AS720S-XAC-ENG 2008.1.25 3:16 PM Page 26