Filter
Top Products
10
Place and Connect Speakers
9
Speaker Placement
Arrange the 6 speakers as shown in your listening area.
● Front Speakers : Set the front speakers so that they are aligned at ear level and at a horizontal angle of 45 degrees to the primary
listening area.
● Rear Speakers : Set the surround speakers further back, parallel to the walls, at 2 to 3 feet above the ear level of the primary
listening area. If the space behind the listening area is limited (i.e., close to the wall), place the rear speakers facing each other on
either side.
● Center Speaker : The center speaker should be positioned with its top surface flush with the front speakers. However, you may
place the speaker either on top of or next to your TV set.
● Subwoofer : Place the subwoofer at any convenient location within the vicinity of the listening area.
Connect Antenna
Connecting the AM (MW)/LW Aerial
1. Complete assembly of the supplied AM loop antenna by
rotating the base and snapping it into place.
2. Connect the two wires from the AM loop antenna to the AM
ANTENNA connector on the back panel. Press down on the
thumb lever to insert each wire, and then release to lock the
wires in place.
Connecting the FM Aerial
Connect the supplied FM antenna to the “FM 75Ω COAXIAL”
connector on the back panel. If noise or interference occurs, use
an external antenna with a 75Ω coaxial cable (not supplied).
Connect the supplied
AM and FM antennas
Connecting your System to the Power Supply
The main lead must be plugged into an appropriate socket.
Before plugging your system into a main socket, you must check
the voltage.
1. Plug the main lead (marked AC Cord on the rear of the
system) into an appropriate socket.
2. Press the On/Standby button to switch your DVD Player
system on.
Listening on headphones
Use headphones for private listening pleasure (not supplied).
Connect the headphones to the HEADPHONES jack of the front
panel.
• No sound is produced from the speakers.
• To prevent hearing damage, do not raise the volume level
excessively when using headphones.
Speaker Connections
1. Make sure the power is turned off before connecting the speakers to prevent possible damage to the speakers.
2. Connect each red and black speaker wire to the system’s back panel as shown, being careful to connect each speaker to its
correctly labeled output.
3. To insert each color-coded wire, press down on the red and black thumb levers and then release them to lock the wires in place.
VIDEO
VIDEO OUT
S-VIDEO
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
ANTENN
A
ANTENNA
FM
75
AM
R
L
VIDEO
VIDEO OUT
S-VIDEO
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
ANTENN
A
ANTENNA
FM
75
AM
AV OUT
Y/C
COMP.
AV OUT
Y/C
COMP.
Phones
Standby
Function
Open/Close
V I D E O
HEADPHONE jack