Filter
Top Products
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
12
Operating your sound system - FM auto-tune
1. Fully extend the telescopic aerial.
2. Press the On / Standby button to switch on your sound system.
3. Press the DAB/FM button to select the FM band.
4. Press and release the Auto-tune button to cause your radio to scan
in the direction previously scanned and stop automatically when it
fi nds a station of suffi cient strength.
5. After a few seconds the display will update. The display will show the
frequency of the signal found. If the signal is strong enough and there
is RDS data present then the radio will display the station name. After
ten seconds the display will revert to showing the time and day.
6. To fi nd additional stations press and release the Auto-tune button
as before.
7. To scan the FM band in a opposite direction rotate the Tuning control
clockwise (to scan low frequency to high frequency) or anti-clockwise
(to scan high frequency to low frequency) and then press the Auto-
tune button again.
8. When the end of the waveband is reached your radio will recommence
tuning from the opposite end of the waveband.
9. Adjust the Volume to the required setting.
10. To switch off your sound system press the On / Standby button.
If you fi nd that an FM broadcast has a lot of background hiss, this may
often be reduced by setting the radio into Mono reception mode for the
current FM station. Please refer to the section "Stereo / Mono setting - FM"
on page 27 for further details.
2,10
3
4-7
7