Filter
Top Products
If you need any further advice, please call our Technical Helpline on :-
020 8758 0338 (Mon-Fri)
4
Using the sound system for the fi rst time
1. Place your sound system on a fl at surface.
2. Fully extend the telescopic aerial. The aerial should be fully extended
and positioned vertically for optimum reception.
3. Plug the cable from the mains adaptor into the DC input socket on
the rear of your sound system (marked 'DC') ensuring that the plug is
pushed fully into the socket. Plug the mains adaptor into a wall socket
and switch on the socket. The display will show "ROBERTS" for a few
seconds and then the display will then show "SCANNING". During
this time the sound system is scanning to fi nd out which DAB radio
stations are available. While scanning markers will show progress of
the scan together with a count of stations found. After a short time the
current time and day will appear on the display.
4. If no stations are found, "NO CLOCK" will be displayed. It may be
necessary to relocate your sound system to a position giving better
reception. You should then carry out a scan to fi nd stations as described
on page 9.
IMPORTANT: The mains adaptor is used as the means of connecting the
sound system to the mains supply. The mains socket used for the sound
system must remain accessible during normal use. In order to disconnect
the sound system from the mains, the mains adaptor should be removed
from the mains socket outlet completely.
Characters appearing on the LCD display indicate that the sound system
is connected to and powered from the mains supply.