14
AMPLIFIER
SAMSON
OUTPUT
CHANNEL 1
CHANNEL 2
MINIMUM LOAD IMPEDANCE
STEREO
(4/CHANNEL)
BRIDGED MONO
(8)
+
-
+
-
+
-
CAUTION
TO PREVENT SHOCK, DO NOT OPEN. NO USER SERVICEABEL PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL. TO PREVENT FIRE OR SHOCK HAZARD. DO NOT EXPOSE TO
RAIN OR MOISTURE.
AVIS ; RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR
DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.
CAUTION ; REPLACE WITH THE SAME TYPE FUSE AS INDICATED.
UTILISER UN FUSIBLE DE RECHANGE DE MEME TYPE.
www.samsontech.com
CHANNEL 1
TIP RING SLEEVE
TIP +
RING -
SLEEVE GND
CHANNEL 2
TIP RING SLEEVE
TIP +
RING -
SLEEVE GND
INPUTS
BRIDGED
STEREO
MODE SELECTOR
(10K / 0dBu)
INPUT
(10K / 0dBu)
INPUT
20A / 250V
PUSH TO RESET
~AC INPUT
115V / 60Hz, 800W
SERIAL NUMBER
115V - 60Hz 800W
POWER
RATING
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN.
INPUT
– +
INPUT
– +
FROM MIXER
PHASE
OFF
AUTO ON
POWER
PEAK
VOLUME
FROM EXTERNAL AMPLIFIER
SPEAKER OUTPUT
SWEEP Hz
PREAMP LEVEL
INPUT OUTPUT
70
40 180
5
010
+-
L
R-+
ON
0° 180°
+-
L
R-+
RR
LL
PHASE
OFF
AUTO ON
POWER
PEAK
VOLUME
FROM EXTERNAL AMPLIFIER
SPEAKER OUTPUT
SWEEP Hz
PREAMP LEVEL
INPUT OUTPUT
70
40 180
5
010
+-
L
R-+
ON
0° 180°
+-
L
R-+
RR
LL
Connecting the SUB120
Stereo Sub With Passive Satellites
Two SUB120’s can be used with any pair of passive or active monitors. Below is a typical system set using two
SUB120’s with a mixer, stereo power amp and a pair of passive satellite loud speakers. The SUB120’s input and
outputs utilize industry standard RCA connectors. For a detailed wiring diagram, see the section SUB120
Connections on page 15. Follow the steps below the diagram to set up your system
• Lower your mixer’s master outputs to all the way off.
• Connect the mixer’s left output to the left side SUB120’s LEFT PREAMP INPUT and the mixer’s right
output to the right side SUB120’s RIGHT PREAMP LEVEL INPUT. Now connect the left SUB120’s LEFT
PREAMP OUTPUT to the left side input of the power amp, and the right SUB120’s RIGHT PREAMP
LEVEL OUTPUT to the right side input of the power amp. Connect a speaker wire from the left output of
your power amp to your left satellite, and then, connect a speaker wire from the right output of your
power amp to your right satellite.
• Now adjust the SWEEP control to the desired frequency. Consult your studio monitors owner’s manual
for a recommended crossover point. You can also use your ears by adjusting the SWEEP control to the
frequency that sounds good to you. A good place to start is about 70 Hz.
• Now set the level of your power amp up to the normal operating level. Run an audio signal (like some
music from a CD) through your mixer and raise the level to a comfortable listening level. Now slowly
raise the SUB120 Volume control and listen to the low frequency output. Adjust the SUB120 to the level
of low frequency output that you like. Now, when you raise and lower your mixer’s output, the SUB120
and satellites will track at the same relative volume.