Samson Sub120 Speaker User Manual


 
12
Connecting the SUB120
FROM MIXER
AMPLIFIER
SAMSON
OUTPUT
CHANNEL 1
CHANNEL 2
MINIMUM LOAD IMPEDANCE
STEREO
(4/CHANNEL)
BRIDGED MONO
(8)
+
-
+
-
+
-
CAUTION
TO PREVENT SHOCK, DO NOT OPEN. NO USER SERVICEABEL PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL. TO PREVENT FIRE OR SHOCK HAZARD. DO NOT EXPOSE TO
RAIN OR MOISTURE.
AVIS ; RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR
DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE.
CAUTION ; REPLACE WITH THE SAME TYPE FUSE AS INDICATED.
UTILISER UN FUSIBLE DE RECHANGE DE MEME TYPE.
www.samsontech.com
CHANNEL 1
TIP RING SLEEVE
TIP +
RING -
SLEEVE GND
CHANNEL 2
TIP RING SLEEVE
TIP +
RING -
SLEEVE GND
INPUTS
BRIDGED
STEREO
MODE SELECTOR
(10K / 0dBu)
INPUT
(10K / 0dBu)
INPUT
20A / 250V
PUSH TO RESET
~AC INPUT
115V / 60Hz, 800W
SERIAL NUMBER
MADE IN KOREA
115V - 60Hz 800W
POWER
RATING
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN.
INPUT
+
INPUT
+
PHASE
OFF
AUTO ON
POWER
PEAK
VOLUME
FROM EXTERNAL AMPLIFIER
SPEAKER OUTPUT
TO PASSIVE SATELLITE SPEAKERS
SWEEP Hz
PREAMP LEVEL
INPUT OUTPUT
70
40 180
5
010
+-
L
R-+
ON
0° 180°
+-
L
R-+
RR
LL
SUB120 120 WATT 10" SUBWOOFER
Lower your mixers master outputs to all the way off.
Connect the mixers left output to the SUB120s LEFT PREAMP LEVEL INPUT and the mixers right out-
put to the SUB120s RIGHT PREAMP LEVEL INPUT. Now connect the SUB120s LEFT PREAMP
LEVEL OUTPUT to the left side input of the power amp, and the SUB120s RIGHT PREAMP LEVEL
OUTPUT to the right side input of the power amp. Connect a speaker wire from the left output of your
power amp to your left satellite, and then, connect a speaker wire from the right output of your power
amp to your right satellite.
Now adjust the SWEEP control to the desired frequency. Consult your studio monitors owners manual
for a recommended crossover point. You can also use your ears by adjusting the SWEEP control to the
frequency that sounds good to you. A good place to start is about 70 Hz.
Now set the level of your power amp up to the normal operating level. Run an audio signal (like some
music from a CD) through your mixer and raise the level to a comfortable listening level. Now slowly
raise the SUB120 volume control and listen to the low frequency output. Adjust the SUB120 to the level
of low frequency output that you like. Now, when you raise and lower your mixers output, the SUB120
and satellites will track at the same relative volume.
Mono Sub With Passive Satellites Using Line Inputs
The SUB120 can be operated using line level inputs and outputs. When using the SUB120 at line level, the full
range signal is maintained at the outputs. Below is a typical system set up using the SUB120 with a mixer, stereo
power amp and a pair of passive satellite loudspeakers. The SUB120s inputs and outputs utilize industry stan-
dard RCA connectors. For a detailed wiring diagram, see the section SUB120 Connections on page 17. Follow
the steps below the diagram to set up your system.