Filter
Top Products
9
Connecting the SUB120
USING THE SUB120 WITH THE SAMSON DMS80 MONITOR SYSTEM
The SUB120 is a great add on to your DMS monitor system providing extended low frequency output. There are
several ways you can interface your new subwoofer to the DMS80, including using the DMS80’s mono SUB
OUT, or by using the DMS 80’s LINE OUTs. The following examples outline the connections and operation for
the SUB120 working with the DMS80 system.
SPEAKER OUTPUTS
LEFT+
LEFT- RIGHT+RIGHT-
SPEAKER IMPEDANCE 4-8
LINE IN AUX IN
SAMSON
DESKTOP MONITOR SYSTEM STEREO 40W X2 MODEL:DA80
MADE IN CHINA
LINE OUT
SUB OUT
MONO
SERIAL
NUMBER
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WARNING
DO NOT EXPOSE THIS EQUIPMENT
TO RAIN OR MOISTURE
AVIS
RISQUE DE CHOC ELECTRONIQUE
NE PAS OUVRIR
CAUTION
FOR CONTINUED PROTECTION AGAINST RISK
OF FIRE, REPLACE ONLY WITH SAME TYPE FUSE
ATTENTION
UTILISER UN FUSIBLE DE
RECHANGE DE MÊME TYPE
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT
INPUT
– +
INPUT
– +
+
–
–
+
PHASE
OFF
AUTO ON
POWER
PEAK
VOLUME
FROM EXTERNAL AMPLIFIER
SPEAKER OUTPUT
TO PASSIVE SATELLITE SPEAKERS
SWEEP Hz
PREAMP LEVEL
INPUT OUTPUT
70
40 180
5
010
+-
L
R-+
ON
0° 180°
+-
L
R-+
RR
LL
SUB120 120 WATT 10" SUBWOOFER
• Make the connections between your mixer and your DMS80 monitor system as described in the DMS80’s
users manual and make sure that you turn your mixer all the way down.
* Connect the SUBWOOFER OUTPUT located on the rear panel of the DMS80 to the RIGHT PREAMP
INPUT on the SUB120.
• Set the SUB120’s Volume control to about 6, and since the DMS80’s SUBWOOFER OUTPUT is High-
passed at 100 Hz, set the SWEEP control to 180Hz.
• Now run some audio, like music on a CD, through your mixer and raise the output to the DMS80 monitor
system to a comfortable listening level.
• Now slowly raise the SUBWOOFER LEVEL control located on the DMS80 front control panel and adjust
the low frequency output to your taste. You can experiment with the balance between the SUB120 and
the DMS satellite speakers by adjusting the SUBWOOFER LEVEL control. Once you find the balance
you like, the SUB120 will track the satellites when you raise or lower your mixer’s output.
Using The DMS80’s SUB OUT