Samson Concert 88 Headphones User Manual


 
79
Sistema Inalámbrico Concert 88
ENGLISH
FRANÇAISDEUTSCHEESPAÑOLITALIANO
Encienda su amplificador o mezclador conectado,
pero mantenga el volumen en el nivel mínimo. Gire
el mando de Volumen del CR88 totalmente en el
sentido contrario a las agujas del reloj (hasta su
posición “10”). Ésta es la ganancia unitaria.
Hable o cante al micrófono o, si está utilizando el transmisor con un instrumento
conectado, toque el instrumento con una intensidad del sonido normal. Suba lenta-
mente el volumen de su amplificador o mezclador hasta alcanzar el nivel deseado.
Si observa que el sistema sufre interrupciones evidentes, su rango operativo es menor
del que debiera o se producen estallidos sonoros imprevistos, cambie el canal opera-
tivo del sistema siguiendo los pasos indicados anteriormente.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
FREQ:
542-566MHz
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
FREQ:
542-566MHz
3. Plug in receiver 4. Turn on receiver
5. Plug receiver into audio system 6. Press Select button to change channel 9. Press and hold SELECT button to IR set 10. Adjust Volume control7. Install batteries 8. Press button on transmitter to turn on
9. Press and hold Select button to IR set7. Install batteries 8. Turn on belt pack transmitter
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
FREQ:
542-566MHz
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
FREQ:
542-566MHz
3. Plug in receiver 4. Turn on receiver
5. Plug receiver into audio system 6. Press Select button to change channel 9. Press and hold SELECT button to IR set 10. Adjust Volume control7. Install batteries 8. Press button on transmitter to turn on
9. Press and hold Select button to IR set7. Install batteries 8. Turn on belt pack transmitter
Inicio Rápido - Configuración de Sistema Simple
Una vez finalizada la transmisión, el CR88 recibirá
la señal de RF y la clave de tono del transmisor. El
indicador READY se iluminará en el panel frontal del
receptor CR88.