Filter
Top Products
100
Accendere l'amplificatore o il mixer collegato,
ma tenerne il volume completamente abbassato.
Ruotare la manopola del volume sul CR88 comple-
tamente in senso orario (sull'impostazione “10” ).
Ciò comporta un guadagno unitario.
Parlare o cantare nel microfono oppure, se si sta usando il trasmettitore con uno
strumento collegato, suonare lo strumento al normale livello che si avrebbe durante
una performance. Alzare lentamente il volume dell'amplificatore o del mixer fino a
raggiungere il livello desiderato.
Se si riscontra che il sistema ha dei drop-out considerevoli, un ridotto range di eser-
cizio complessivo o improvvise manifestazioni di rumore, modificare il canale su cui
il sistema funziona effettuando le operazioni sopra elencate.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
FREQ:
542-566MHz
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
FREQ:
542-566MHz
3. Plug in receiver 4. Turn on receiver
5. Plug receiver into audio system 6. Press Select button to change channel 9. Press and hold SELECT button to IR set 10. Adjust Volume control7. Install batteries 8. Press button on transmitter to turn on
9. Press and hold Select button to IR set7. Install batteries 8. Turn on belt pack transmitter
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
FREQ:
542-566MHz
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
FREQ:
542-566MHz
3. Plug in receiver 4. Turn on receiver
5. Plug receiver into audio system 6. Press Select button to change channel 9. Press and hold SELECT button to IR set 10. Adjust Volume control7. Install batteries 8. Press button on transmitter to turn on
9. Press and hold Select button to IR set7. Install batteries 8. Turn on belt pack transmitter
Guida introduttiva - Configurazione di un sistema singolo
Quando la trasmissione è completa, il ricevitore CR88
riceverà il segnale in RF e il tone key dal trasmettitore.
Sul pannello frontale del ricevitore CR88 lampeggerà la
spia indicante lo stato di PRONTO.