Filter
Top Products
62
MACRO EDITOR (MacEd)
This procedure is used to create a sequence of commands that are launched with one key touch or
other event. Up to 132 macros can be created for the system, and each macro can contain up to 10
commands including other macros and delays.
See Macro Editor - Flow Chart on page 75
1. MACRO ID – Number of Macro up to 132 including any previously named
(MacID) macros.
2. MACRO NAME – Name of Macro (optional).
(MacNm)
3. COMMAND NUM – Number of Command up to 10.
(Cmd#)
4. COMMAND TYPE – Select the type of source command (e.g., CD, TV, etc.).
(CmdTp)
a. Selected: Learned IR Choose Learned IR if the pre-programmed IR code library does
(LrnIR) not support the source component.
i. LEARNED SRC – Select the learned source bank to be assigned to the source
(LnSrc) component. Procedure advances to KEY FUNCTION (step 6)
b. Selected: Unassigned Selected command and subsequent commands are cleared.
(Unasg) Procedure advances to COMMAND NUM (step 3)
c. Selected: Default Default selects the same device type and device code previously
(Deflt) setup in BASIC SETUP. Procedure advances to KEY FUNCTION
(step 6)
d. Selected: Macro:
(Macro)
i. MACRO - A macro can “call” another macro if a sequence of more than 10
(Macro) commands is needed.
ii. MACRO ID – Enter the macro ID number. Menu advances to COMMAND NUM
(MacID) (step 3)
e. Selected: Delay Enter a 1- to 60-second delay time to postpone delivery of the
(Delay) next command in the macro. Procedure advances to COMMAND
NUM (step 3)
f. All Other Selections: Procedure advances to DEVICE CODE (step 5)
(continued next page)
INSTALLER
INSTALLATION MENU