Filter
Top Products
Installation
56 Runco SC-30d/SC-35d Installation/Operation Manual
PRE
L
IMINAR
Y
Attach Lens Mounting Assembly to Lens Motor Carriage Plate:
1. Remove the two Yaw/X Adjustment Levers and Washers (8) from the bottom of the
Anamorphic Lens Holder (6).
2. Place the Anamorphic Lens Holder on top of the AutoScope Carriage Plate or Fixed
CineWide Base Plate (7). Position the bracket so that the long slot at the bottom of
the lens holder is perpendicular to the corresponding slots on the plate.
3. Secure the Anamorphic Lens Holder to the plate using the Hex Bolts/Washers (9) and
Yaw/X Adjustment Levers that you removed in Step 1.
4. Use the Height/Y Adjustment T-Screws/Washers (4), Pitch Adjustment
T-Screws/Washers (5) and T-Nuts (1) to attach the Pitch Adjustment Yoke and Lens
Adapter Ring to the Anamorphic Lens Holder. The Yoke should be as close to the
primary lens as possible.
5. Attach the lens to the Lens Adapter Ring by threading it clockwise.
Figure 3-30. Attaching the Anamorphic Lens to the Lens Ring
Lens threads into ring
F
O
C
U
S