Filter
Top Products
Operation
100 Runco SC-30d/SC-35d Installation/Operation Manual
PRE
L
IMINAR
Y
Turning On the Glasses 1. Ensure that the projector is powered on and displaying 3D content.
2. Press and hold the Power Button for about two seconds, then release the button. The
LED will then blink in a pattern that indicates the battery charge state. In general, the
more slowly and less frequently the LED blinks, the more charged (and less in need of
charge) the glasses are. Refer to Table 4-5.
3. The glasses will sync with the emitter and the 3D content will be visible through the
glasses.
4. Repeat Step 2 for each pair of glasses you wish to sync to the emitter.
Auto Power-Off If the glasses do not detect an emitter, the LED blinks on and off once per second for five
minute. Then, to preserve battery life, the glasses automatically turn off. If the emitter is
activated (the emitter is only active when the projector is in 3D mode) before the
five-minute period ends, the glasses stop blinking and remain on.
If the glasses automatically turn off, press the Power button to turn them back on.
➤
Table 4-5. Battery Charge State Indications
Blink Activity After
Power-on
Battery Charge State
Three (3) blue blinks (one
second on, one second off)
Battery is fully charged; 12 to 15 hours remaining.
Six (6) blue blinks Battery is 50% charged; approximately 4 hours remaining.
Nine (9) blue blinks Battery is 30% or more charged; approximately 2 hours remaining.
Red blink Battery charge is 10% or less; glasses must be charged before
further use.
➤