Filter
Top Products
Q-750i Series Installation/Operation Manual 43
PRE
L
IMINAR
Y
4.1
Selecting An Input
Source
When you turn on the Q-750i, it switches to the last selected input and looks for a valid
signal.
Use these buttons on the remote control to select an
input source directly.
You can assign the HD 1, HD 2 and HD 3 buttons to any
input. The default assignments are:
HD
1 = Component 1, HD 2 = Component 2,
HD
3 = RGB.
For more information, refer to HD 1 Key / HD 2 Key / HD 3 Key on page 66.
4.2
Using
Picture-In-Picture (PIP)
For PIP purposes, there are three groups of inputs separated by their display modes:
• Video (SD) group: Video, S-Video and SCART inputs.
• Graphic (HD) group: Component 1, Component 2 and RGB inputs.
• Digital Video group: HDMI 1 and HDMI 2 inputs.
PIP shows one input from any of these groups within or beside one input from either of the
other two groups.
For more information, refer to PIP Position on page 63.
4. Operation
VID S-VID HDMI1
HD2
SOURCE
HD1 HD3
HDMI2