Filter
Top Products
Installation
Q-750i Series Installation/Operation Manual 19
PRE
L
IMINAR
Y
3.4
Installing the Optional
CineWide/AutoScope
Lens Mount
If you are installing a standard (non-CineWide) Q-750i, skip this step and proceed with
Mounting the Q-750i (page 26).
If you are installing a Q-750i/CineWide projector equipped with a
cylindrical (Rainier
II or McKinley) anamorphic lens, proceed
with Installing the Fixed CineWide Base Plate (page 24).
If you are installing a Q-750i/CineWide with AutoScope, proceed as follows to install the
AutoScope lens motor.
1. Do not install the CineWide lens yet, only the fixed CineWide
base plate or AutoScope lens motor. You will install the CineWide
lens after you install the projector and adjust the primary lens.
2. Some components shipped with your projector may differ slightly
from what is shown in these instructions.
F
O
C
U
S
Note