Filter
Top Products
Installation
20 Runco LS-7 Installation/Operation Manual
PRE
L
IMINAR
Y
3.5
Connections to the
LS-7
Proceed as follows to connect the LS-7 to your video sources, external controller(s) – if
present – and AC power.
When connecting your equipment:
• Use the correct signal cables for each source.
• Ensure that the cables are securely connected. Tighten the thumbscrews on
connectors that have them.
Connector Panel Access Using a flat-blade screwdriver, loosen the two
screws holding the rear compartment cover
in place.
Then, remove the rear compartment cover by
tilting it upward.
➤