Filter
Top Products
11
English
Specifications
Total Harmonic Distortion + Noise 0.0045% @ 1kHz
Intermodulation Distortion 0.0045% @ 1kHz
Frequency Response (±0.5 dB) 20-20,000 Hz
Channel Balance ± 0.5 dB
Phase Linearity ± 0.5 degree
Channel Separation > 98 dB @ 1kHz
Signal to Noise Ratio > 100dB
Dynamic Range > 96 dB
Digital to Analog Converters Wolfson
Speed Accuracy, Wow & Flutter Quartz Crystal Precision
Maximum Audio Line Output 2V RMS
Output Impedance 100 Ohms
Digital Output Level (coax) 0.5 Volt, Peak to Peak
Digital Output Impedance 75 Ohms
Power Requirements
USA Version AC 120V, 60 Hz
European Version AC 230V, 50 Hz
Power Consumption 20 Watts
Dimensions (W x H x D) 17 x 4 x 12
5
/8 inches
431 x 99 x 320 mm
Front Panel Height (for rack mount) 2U / 3
1
/2 inches / 88.1 mm
Weight (net) 6.5 kg, 14.3 lb.
All specifications are accurate at the time of printing. Rotel reserves the right to
make improvements without notice.
Rotel and the Rotel HiFi logo are registered trademarks of The Rotel Co, Ltd.,
Tokyo, Japan.
Troubleshooting
Most difficulties in audio systems are the result of incorrect
connections, or improper control settings. If you encounter problems,
isolate the area of the difficulty, check the control settings, determine
the cause of the fault and make the necessary changes. If you are
unable to get sound from the RCD-1520, refer to the suggestions for
the following conditions:
Power Indicator Is Not Lit
The Power Indicator and the basic items in the Display window should
be lit whenever the RCD-1520 is plugged into the wall power outlet
and the Power button is pushed in. If it does not light, test the power
outlet with another electrical device, such as a lamp. Be sure the
power outlet being used is not controlled by a switch that has been
turned off.
Fuse Replacement
If another electrical device works when plugged into the power outlet,
but the Power Indicator and the Display still will not light when the
RCD-1520 is plugged into the wall outlet, it indicates that the internal
power fuse may have blown. If you believe this has happened, contact
your authorized Rotel dealer to get the fuse replaced.
No Sound
Check the cables between the RCD-1520 and the amplifier inputs
to be sure they are connected properly. Be sure the amplifier input
that the RCD-1520 is selected. Be sure the tape monitor system of
the amplifier has not been activated. Check the wiring between the
amplifier and the speakers.