Filter
Top Products
9
English
ExternalRemoteInput
w
This 3.5 mm mini-jack (labeled EXT REM IN) receives command codes
from an industry-standard infrared receiver (Xantech, etc.) located in the
main listening room. This feature is useful when the unit is installed in a
cabine and the front-panel sensor is blocked. Consul your authorized
Rotel dealer for information on external receivers and the proper wiring
o a jack to fit the mini-jack receptacle.
12V Trigger Connection
q
The RCD-06 SE can be activated by a 12 volt trigger signal from a Rotel
preamplifier. The trigger input accepts any control signal (AC or DC)
ranging from 3 volts to 30 volts. When a cable is connected to the input
and a trigger signal is present, the CD Player is activated.
When the trigger signal is interrupted, the unit goes into standby mode.
The front panel indicator light remains lit , but the display goes dark and
the unit will not operate.
Note: When using the 12V Trigger feature, leave the POWER button
in the ON position.
Troubleshooting
Most difficulties in audio systems are the result of incorrect connections,
or improper control settings. If you encounter problems, isolate the area
of the difficulty, check the control settings, determine the cause of the fault
and make the necessary changes. If you are unable to get sound from the
RCD-06 SE, refer to the suggestions for the following conditions:
Power Indicator Is Not Lit
The Power Indicator and the basic items in the Display window should be
lit whenever the RCD-06 SE is plugged into the wall power outlet and the
Power button is pushed in. If it does not light, test the power outlet with
another electrical device,such as a lamp. Be sure the power outlet being
used is not controlled by a switch that has been turned off.
Fuse Replacement
If another electrical device works when plugged into the power outlet,
but the Power Indicator and the Display still will not light when the
RCD-06 SE is plugged into the wall outlet, it indicates that the internal
power fuse may have blown. If you believe this has happened, contact
your authorized Rotel dealer to get the fuse replaced.
NO SOUND
Check the cables between the RCD-06 SE and the amplifier inputs to be
sure they are connected properly. Be sure the correct amplifier input is
selected. Be sure the tape monitor system of the amplifier has not been
activated. Check the wiring between the amplifer and the speakers.
Specifications
Total Harmonic Distortion + Noise 0.0045%@1kHz
Intermodulation Distortion 0.0045%@1kHz
Frequency Response (±0.5db) 20-20,000 Hz
Channel Balance ±0.5db
Phase Linearity ±0.5degree
Channel Separation > 98 dB @ 1kHz
Signal to Noise Ratio > 100dB
Dynamic Range > 96 dB
Digital to Analog Converters Wolfson
Speed Accuracy, Wow & Flutter Quartz Crystal Precision
Output Impedance 100 Ohms
Digital Output 0.5 Volt, Peak to Peak
Load Impedance 75 Ohms
Power Requirements AC 230V, 50 Hz
Power Consumption 20 Watts
Dimensions (W, H, D) 17
1
/8" x 2
7
/8" x 12
5
/16"
437 x 73 x 313 mm
Panel Height 60 mm / 2
3
/8"
Weight (net) 5 kg, 11lbs
All specifications are accurate at the time of printing.
Rotel reserves the right to make improvements without notice.
Rotel and the Rotel HiFi logo are registered trademarks of
The Rotel Co, Ltd., Tokyo, Japan.