Filter
Top Products
9
Deutsch Français Italiano Español Português NederlandsEnglish
HPF
RECEIVER
DAC
LPF PHASE
NOR
INV
SPEAKER
WOOFER
EQUALIZER
LOW HIGH
MASTER
L
R
SATELLITE SPEAKER
CH1
INSTRUMENT
L/MONO
R
R
L
STEREO
DIGITAL
R
L
CH2
LINE
CH3
DIGITAL
PHONES
INPUT
INPUT
RL
OUT
POWER
AMP
POWER
AMP
BALANCED
INPUT
Block Diagram
Problem Cause Action Page
System won’t turn on
Is the Power cord correctly connected to an electrical
outlet?
Make sure that the Power cord is correctly connected to an
electrical outlet.
p. 5
No sound
Is the external equipment connected correctly?
Check the type of jack and plug, and make the correct
connections.
—
Are each of the knobs adjusted correctly? Turn the knobs toward the right to raise the volume. p. 6
Could the Auto O function have operated?
Turn the system o, then on again; or turn o the [AUTO OFF]
switch.
p. 6
Could you be inputting an analog signal to the CH 3 jack?
Connect a coaxial cable to the CH 3 jack, and connect the other
end to the digital output jack of your equipment.
p. 5
Could you be inputting a digital signal such as 5.1 channel
audio to the CH 3 jack?
Input a stereo digital signal. p. 7
Could you have connected speakers other than the
included satellite speakers?
Use the included satellite speakers. p. 4
Could you be using cables other than the included
speaker cables?
Use the included speaker cables. p. 4
Sound is distorted or noisy
Could the respective knob be raised excessively?
Turn the respective knob toward the left to adjust the volume
appropriately.
p. 6
Is the input level from the connected device appropriate? Lower the volume of the connected device. —
Could you be inputting a digital signal such as 5.1 channel
audio to the CH 3 jack?
Input a stereo digital signal. p. 7
Insucient volume
Is each knob adjusted correctly? Turn the knobs toward the right to raise the volume. p. 6
Is the input level from the connected device appropriate? Raise the volume of the connected device. —
Could you have connected speakers other than the
included satellite speakers?
Use the included satellite speakers. p. 4
Could you be using cables other than the included
speaker cables?
Use the included speaker cables. p. 4
Could you be using a connection cable that contain a
built-in resistor?
When making connections to the INPUT jacks, use connection
cables that do not contain built-in resistors.
—
Troubleshooting