Rockford Fosgate 55.2 Stereo Amplifier User Manual


 
B
ATTERY
AND
C
HARGING
– 9 –
Amplifiers will put an increased load on the vehicle's battery and charging
system. We recommend checking your alternator and battery condition to
ensure that the electrical system has enough capacity to handle the
increased load of your stereo system. Stock electrical systems which are in
good condition should be able to handle the extra load of any Rockford
amplifier without problems, although battery and alternator life can be
reduced slightly. To maximize the performance of your Rockford Fosgate
amplifier, we suggest the use of a heavy duty battery and an energy storage
capacitor.
W
IRING
THE
S
YSTEM
CAUTION:
Avoid running power wires near the low level input cables,
antenna, power leads, sensitive equipment or harnesses. The power
wires carry substantial current and could induce noise into the audio
system.
For safety, disconnect the negative lead from the battery prior to beginning
the installation.
1. Configure the internal XCard crossovers prior to installation. Refer to
“Using the XCard” (page 14) for further information.
2. Plan the wire routing. Take care when running signal level RCA cables
to keep them close together but isolated from the amplifier's power cables
and any high power auto accessories, especially electric motors. This is
done to prevent coupling the noise from radiated electrical fields into the
audio signal. When feeding the wires through the firewall or any metal
barrier, protect them with plastic or rubber grommets to prevent short
circuits. Leave the wires long at this point to adjust for a precise fit at a
later time.
3. Prepare the Power cable for attach-
ment to the amplifier by stripping 5/8"
of insulation from the end of the wire.
To prevent the wire from fraying, strip
the insulation at a 45° angle. Insert
the bared wire into the B+ terminal
with the long side of the insulation on
the top. Bend the cable down at a 90°
angle. Tighten the set screw to secure
the cable in place.
><
5/8"
INSULATION
STRIP WIRE
>
>
AMP
>