Ricoh 33-1196 Headphones User Manual


 
Troubleshooting
6
6417$.'5*116+0)
We do not expect you to have problems with your
headphones, but if you do, these suggestions might help.
6*'"(%%"9#065";17"61"-019
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the
FCC Rules
. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference
by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult your local RadioShack store or an experienced
radio/TV technician for help.
If you cannot eliminate the interference, the FCC
requires that you stop using your headphones.
2TQDNGO 5QNWVKQP
No sound
Be sure the headphones are turned on.
Replace or charge the headphones’ batteries.
Be sure the AC adapter is plugged in and has power.
Be sure all cables are securely connected.
Be sure the audio source is turned on.
Be sure the source’s volume control is turned up.
Adjust the headphones’ volume control.
Change the position of the transmitter.
Distorted
audio
If you connected the transmitter to an audio source’s
headphone jack, reduce the audio source’s volume.
Charge or renew the headphones’ batteries.
Change the position of the transmitter.