Filter
Top Products
Connecting to an Audio Source
4
7. The batteries automatically begin charging and the
transmitter’s CHARGE indicator lights green.
Before using your headphones for the first time, you must
charge the batteries for at least 24 hours. When the
batteries have been completely discharged, it takes about
12 hours to completely recharge the batteries.
When charging is complete, unplug the charge cord. The
CHARGE indicator turns off.
4'%;%.+0)"0+/%&"$#66'4+'5
The EPA certified RBRC
®
Battery Recycling
Seal on the nickel-cadmium (Ni-Cd) battery
indicates RadioShack is voluntarily participating
in an industry program to collect and recycle these batteries
at the end of their useful life, when taken out of service in
the United States or Canada. The RBRC program provides
a convenient alternative to placing used Ni-Cd batteries into
the trash or the municipal waste stream, which may be
illegal in your area. Please call 1-800-THE-SHACK (1-800-
843-7422) for information on Ni-Cd battery recycling and
disposal bans/restrictions in your area. RadioShack’s
involvement in this program is part of the company’s
commitment to preserving our environment and conserving
our natural resources.
%100'%6+0)"61"#0"#7&+1"
5174%'
You can connect the transmitter to your audio source’s left
and right audio output jacks or the headphone jack.
.
..
.
1. Connect one end of the supplied audio patch cord to
the transmitter’s audio jacks (white plug to
L AUDIO IN
and red plug to
R AUDIO IN
).
2.
If you are using the audio source’s output jacks,
connect the white and red plugs at the other end of the
patch cord directly to the audio source’s corresponding
left (white) and right (red) audio jacks.
If you are using your audio source’s stereo headphone
jack,
connect the patch cord’s white and red plugs to
the white and red phono jacks on the Phono to
1
/
8
-inch
supplied adapter.
3.
If your audio source has a
1
/
8
-inch headphone jack,
insert the adapter’s
1
/
8
-inch stereo plug into the audio
source’s HEADPHONE jack.
.
"%#76+10"
.
Do not connect the transmitter to
your audio source’s speaker
output. Doing so could damage the
transmitter and audio source.