Ricoh 33-1196 Headphones User Manual


 
Choosing a Location
2
%*115+0)"#".1%#6+10
Many factors affect the range of your system. To achieve
the best performance:
Position the transmitter as far as possible from other
electronic devices such as TVs, receivers, or VCRs.
Radio interference from these devices could affect your
system’s performance.
Position the transmitter away from large metal objects,
as these could block your transmitter’s signals.
Try several locations for the transmitter. Select the
location that provides the best performance.
Your system’s overall performance depends on your home’s
construction method, the other devices near the system,
and other radio frequency sources in your home (such as
cordless telephones).
75+0)"#%"219'4
Use the supplied 12V, 250mA AC adapter to connect the
transmitter to AC power.
Plug the supplied AC adapter’s barrel plug into the
transmitter’s
DC IN 12V
jack, then plug the adapter into a
standard AC outlet.
.
..
.
+056#..+0)"$#66'4+'5"
Your headphones require three AAA alkaline batteries or
rechargeable batteries (neither supplied) for power.
.
..
.
1. Remove the battery
compartment cover
on the left earpiece
by pulling the side of
the cover and lifting
the cover off.
2.
If you are using
alkaline batteries,
set
ALK/RCH
inside the compartment
to
ALK
.
If you are using rechargeable batteries,
set
ALK/RCH
to
RCH
.
3. Place the batteries in the compartment according to the
polarity symbols (+ and –) marked in the compartment.
4. Slide the cover back on until it clicks into place.
.
"%#76+10"
.
You must use a Class 2 power
source that supplies 12 volts DC
and delivers at least 250mA. Its
center tip must be set to positive
and its plug must fit the
transmitter's DC IN 12V jack. The
supplied adapter meets these
specifications. Using an adapter
that does not meet these
specifications could damage the
transmitter or the adapter.
Always connect the AC adapter
to the transmitter before you
connect it to AC power. When
you finish, disconnect the
adapter from AC power before
you disconnect it from the
transmitter.
Use only fresh batteries of the
required size and recommended
type.
Do not mix old and new batteries,
different types of batteries
(standard, alkaline, or
rechargeable), or rechargeable
batteries of different capacities.
If you do not plan to use the
headphones for a week or
longer, remove the batteries.
Batteries can leak chemicals that
can destroy electronic parts.
ALK/RCH