Filter
Top Products
2
To Add and Erase Channels from TV’s Memory
1. To add or erase a channel, repeatedly press TV MENU to highlight Setup Menu, and
then press + or – to display the setup functions. Repeatedly press TV MENU to
highlight the Chan Mem function.
2. Press CHANNEL up or down (or the two corresponding number buttons on the
remote) to select the desired channel you wish to add or erase.
3. Press the + button to add the channel to memory, or press the – button to erase the
channel from memory.
Chan Label
Parental Ctrl: Off
Chan Ctrl: Normal
Autoprogram
Chan Mem: Stored
Mute
Video Menu
Audio Menu
Setup Menu
Your TV must be programmed for the system to operate properly. If it was not programmed,
complete these programming functions.
For complete operating information on your TV, see the UserÕs Guide for your TV.
To
Autoprogram TV’s Channel Memory
1. Press TV on the remote to turn on the TV and audio/video receiver. Select an active
channel on the TV. Adjust the volume, if necessary.
2. Press TV MENU on the remote repeatedly until Setup Menu is highlighted. Press + on the
remote once and then press TV MENU repeatedly until Autoprogram is highlighted.
3. Press + to begin autoprogramming. The TV will first program all channels for ANT A
input and then program all channels for ANT B input. (Do not press any buttons until the
TV has finished autoprogramming itself.)
Mute
Video Menu
Audio Menu
Setup Menu
Set Alarm
Chan Label
Parental Ctrl: Off
Chan Ctrl: Normal
Autoprogram
Set Alarm
Chan Label
Parental Ctrl: Off
Chan Ctrl: Normal
Autoprogramming
4. When the TV is finished cycling, you can check to see which channels are in memory by
pressing CHANNEL up or down on the remote.
4. Be sure channel 91 has been added for the VCR, channel 92 has been added for the
Laserdisc player, and channel 90 has been added if an optional satellite receiver is
being used. Repeat steps 1-3 to add these channels. This lets you access these video
inputs as regular channels when you press CHANNEL up or down.
Setting Up Your TV
Chan Label
Parental Ctrl: Off
Chan Ctrl: Normal
Autoprogram
Chan Mem: Erased