Filter
Top Products
16
The audio/video receiver tunes in the signals for AM and FM radio stations in your area, and
controls the sound output for the TV, VCR, laserdisc Player, CD changer, and satellite receiver
(optional for some systems).
To Listen to AM/FM Stations
1. Press AM•FM on the remote to turn on the receiver and set the remote to operate the
receiver. Repeatedly press the AM•FM button to toggle between AM and FM mode.
2. Press CHANNEL up or down on the remote or TUNING 2 or 1 on the receiver to tune
the radio to a preferred station.
To Preset AM/FM Stations
1. Tune in the desired station by pressing TUNING 2 or 1 on the receiver.
2. Press MENU/PROGRAM on the remote or MEMORY on the front of the receiver.
While the word MEMORY is displayed in the display panel, press the number buttons
to select the preset channel where the station is to be stored (01-30). For example, press
0 then 3 to store the station which is tuned to memory location 3.
3. Repeat steps 1 and 2 for up to 30 stations.
4. Once stations are preset, you can use CHANNEL up or down on the remote to scan
through the preset channels. You can also go directly to preset stations using the
number buttons.
To Adjust Basic Sound Controls
1. Press VOLUME up (>) or down (<) on the remote or adjust the VOLUME control on the
receiver to increase or decrease the volume.
2. Adjust the BALANCE control on the receiver to balance the level of sound from the left
and right front speakers. The center position is recommended.
3. Adjust bass and treble. The bass and treble displays will flash during adjustment, and
then time out.
¥To adjust bass, press BASS on the receiver and then press up 2 to increase bass and
down 1 to decrease bass.
¥To adjust treble, press TREBLE on the receiver, and then press up 2 to increase treble
and down 1 to decrease treble.
Using Your Audio/Video Receiver
Caution: To prevent speaker damage, make sure volume is turned down to a reasonable level
before the receiver is turned on.