RCA CDRW120 CD Player User Manual


 
Chapter 1 : Setup & Connections
Chapter 1 3
Things to Consider Before Connecting Components
Protect Components From Power Surges
Connect all components before plugging any power cords into the wall outlet.
Always turn off the TV and other components before you connect or disconnect any
cables.
Position Cables to Avoid Audio Hum or Interference
Insert all cable plugs firmly into their jacks.
Place any Audio/Video (A/V) cables to the side(s) of the TV’s back panel instead of
straight down the back after connecting components.
•Try not to coil any twin-lead cables and keep them away from all A/V cables as
much as possible.
Make sure all antennas and cables are properly grounded. Refer to the Safety Tips
sheet packed with your unit for detailed information.
Protect Components From Overheating
Never block ventilation slots in any component. Arrange the components so that air
can circulate freely.
Do not stack components.
Allow adequate ventilation when placing components in a stand.
Place an amplifier or satellite receiver on the top shelf of a stand so heated air rising
from it will not flow around other components.
15920520.01 Connections 9/24/02, 3:54 PM3