Filter
Top Products
6
BEFORE YOU MAKE THE
CONNECTIONS
The supplied connection cables in-
clude all the lead wires you need to
connect the amplifier to ground, power,
and your existing autosound system.
Important:
• Do not cut these wires. If you cut
any wire, you cannot obtain a
refund or exchange on this prod-
uct. However, RadioShack
will
provide warranty service if you cut
a wire and find the product is
defective.
• If the connectors on your vehicle’s
autosound system are not com-
patible with the amplifier’s con-
nectors, you might need an
adapter harness to complete the
connections. RadioShack stores
sell adapter harnesses for most
vehicles.
You might need additional wire, de-
pending on your individual autosound
system, to complete the connections.
Your local RadioShack store carries a
full line of wire and wire management
accessories.
Cautions:
• For added safety and to protect
your amplifier and autosound sys-
tem, disconnect the cable from
your vehicle’s negative (–) battery
terminal before you begin.
• Be sure your front speakers can
handle as much as 20 watts per
channel and your rear speakers
as much as 55 watts per channel
of power. Each speaker must
have an impedance of at least 4
ohms. Your local RadioShack
store carries a full line of speak-
ers.
To make it easier to gauge wire length
and connect the amplifier, temporarily
place the amplifier as close as possible
to the selected mounting location.
12-2015.fm Page 6 Tuesday, July 13, 1999 3:47 PM