Filter
Top Products
23
REPLACING A FUSE
If the amplifier does not operate, you
might need to replace the red power
cable’s 25-amp SFE-type fuse or the
25-amp blade-type fuse on the amplifi-
er’s back panel. Check both fuses.
Important:
Let the amplifier cool
down and see if it starts again before
you assume a fuse needs to be re-
placed.
Caution:
Do not use a fuse with rat-
ings other than those specified here.
Doing so might damage your amplifi-
er.
Replacing the SFE-Type Fuse
1. Disconnect the cable from the
vehicle’s negative (–) battery ter-
minal.
2. Push together and twist the fuse
holder’s parts on the red power
cable until they spring apart. Then
remove the fuse.
3. If the fuse is blown, replace it. Use
only an SFE-type fuse with the
proper rating (available at many
automotive supply stores). The
fuse must be 25 amps.
4. Reassemble the fuse holder by
inserting the fuse into the longer
of the fuse holder’s ends, and
pushing together and twisting the
two parts until they latch.
5. Reconnect the cable to the vehi-
cle’s negative (–) battery terminal.
(illus - show fuse holder)
12-2015.fm Page 23 Tuesday, July 13, 1999 3:47 PM