QSC Audio Network Audio Systems Speaker System User Manual


  Open as PDF
of 6
 
Input
Sensitivity
3V / 1V
Port A Ch 1
Audio
Inputs
DataPort A
Input
Source
Normal
/ Page
Meter
Mon (Pre)
Meter
Mon (Pre)
Meter
Mon (Post)
Mon (Amp)
Mon (Amp)
Meter
Mon (Post)
Input
Sensitivity
3V / 1V
Mute Polarity
Parallel
Stereo Mode
Input
Source
Normal
/ Page
Level Control
-95.5 to 0 dB
0.5 dB steps
Mute Polarity
Level Control
-95.5 to 0 dB
0.5 dB steps
Output
Open
Detect
Output
Open
Detect
Output
Short
Detect
Output
Short
Detect
Protect
Status
Detect
Protect
Status
Detect
Load
Monitor
Detect
Load
Monitor
Detect
Power
Status
Detect
Amp
Model
Detect
Standby /
Operate
Control
Bridge
Mode
Detect
Real
Power
Detect
Real
Power
Detect
Clip
Detect
Clip
Detect
Amp
Gain
Detect
Amp
Gain
Detect
Over-
temp
Detect
Over-
temp
Detect
Heat-
sink
Temp
Heat-
sink
Temp
Head-
room
Meter
Head-
room
Meter
Output
Current
Meter
Output
Current
Meter
Output
Voltage
Meter
Output
Voltage
Meter
Input
Sensitivity
3V / 1V
Input
Page
RS-232 Ethernet
Input Output
Monitor
Chain
Monitor
Chain
Port A Ch 2
Ch 1
Ch 1
Functions
Ch 2
Functions
Amp Functions
RLY
Out
RLY
Trig in
Serial I/O (DB-9)
Internal
Micro-Controller
Ch 2
DataPorts B through H (same as DataPort A)
Audio Monitor Chain
(Summing Bus)
Internal DAC
(for Test Tones
and Playback)
NCNO
C
Contact
Closure
I/O
RLY
From
Tap Points
Mon
Power Amplifier DataPort Interface
Up to four signals may be
sent to the Monitor Bus at
one time. Each tap has
its own gain adjust.
Mon 1
Mon 2
Mon 3
Mon 4
Block Diagram of the CM16a
QSControl Network Audio Systems
Processor 866 MHz Intel Pentium™ III processor
RAM 128 MB, 133 MHz bus
Hard Disk 4 GB or greater Ultra DMA
Floppy 3.5" 1.44 MB drive
CD-Rom 40x or greater IDE
Network 10/100
BASE-T
Network Configuration TCP/IP host
Modem 56k V.90 internal PCI (optional)
Video 2D/3D Graphics, 133/100 MHz, 4 MB Display cache or better
Sound Sound Blaster® compatible (optional)
Keyboard 104 key, PS/2 compatible
Mouse PS/2 compatible
Operating System Windows NT-4 (SP-6) or Windows 2000 (SP-2)
All specifications are subject to change.
Minimum Recommended Specifications for the System Controller
 previous