Filter
Top Products
Part 8
when disconnecting any connector. Failure to do this could damage the cable
and jack that is considered as an artificial destruction. Damages due to
incorrect disconnection operation are not covered by product warranty!
SEPARATING MAIN UNIT
In order to settle the touch terminal properly in a point of sale system,
all the cable connections have to be routed through its base. Therefore, please
observe the procedures from A to C below to separate the main unit from the
base stand assembly after all cables in cable cover disconnected.
OPENING SLIM BASE BOTTOM
Take the adjustable stand assembly of the gen
5 slim base and turn it up side down to show the
bottom of the base. Remove the bottom plate fixing
screws in center of rubber feet to remove the bottom
plate. For maintenance operation that there are already
some cable connections, please release the cables from
the 2 plastic cable holders and have all cables to pass
through the cable passage in bottom plate as in the left
picture.
INSTALLING UPS BATTERY (OPTION)
The optional UPS battery is delivered in the carton if it is ordered. For
slim base model, please refer to the left picture and
place the UPS battery in the cavity in base with the
rectangular marked end first. Route the battery
connection cable together with all other external
connection cables through the arrow marked passage
to the battery connector on the main unit. If the
optional cable clip is available, insert it into a hole
marked in circle in the picture and use it to hold the
Step A: Prepare a soft clean flat surface, such
as a piece of cloth on the desk to seat
the front surface of main unit after
being adjusted to most horizontal
position
Step C: Slide the base stand assembly to left to
separate the main unit from base stand
C
A
B
Step B: Press the Lock/Release button for
main unit detach and meantime ...
C
A
B
w/ Gen 5 base
w/ Gen 6 base
Gen 5 base
Gen 5 base