Filter
Top Products
SR-H1000 CI Guide Page 9 2/28/2008
Revision 1.0
II. 12 Volt Trigger:
The 12V Trigger Input allows your 12V-trigger-capable preamp or receiver to force the
SR-H1000 Tuner to go from STANDBY mode (power button illuminated, front panel
display off) into ON mode (power button not illuminated, front panel display on) or vice
versa without the need to press the POWER button. To disable the 12V Trigger Input
feature, simply do not connect anything to the 12V Trigger Input jack on the rear panel of
the Tuner. To enable this feature, connect a 1/8" mono plug cable (tip +/ barrel - ) from
your preamp or receiver's 12V Trigger Output to your SR-H1000 Tuner's 12V Trigger
Input jack on the rear panel. So long as the Tuner stays plugged into an active AC outlet,
your SR-H1000 Tuner is ready to respond to power mode changes sent from your preamp
or receiver.