Filter
Top Products
SR-H1000 CI Guide Page 11 2/28/2008
Revision 1.0
The tuner will only stay in "Pass-through" mode until the power is cycled, a power cycle
will exit this mode.
When the tuner is in RS232 Operation mode, the front panel controls & display are
disabled and only communication over the RS-232 interface is possible.
If the control system you are working with (Crestron, Niles, AMX, Russound, etc) has
firmware with the Sirius SSP protocol (the firmware that enables a device to be “Sirius
Ready”) then it can control the SR-H1000 with the same command sets. If the
manufacturer of the control system you are using has not made arrangements with Sirius
to provide the SSP protocol, they will need to contact Sirius directly and sign a non-
disclosure agreement.