Filter
Top Products
Polk customer service (800) 377-7655
POWER
+
—
—
+
SUB
WOOFER
VOLUME
late
surround
on/off
— radio tuner
night
radio preset +
+
—
audio
FM
SOURCES
DVDcable-LD
radio
AM preset scan
mute
audio
video/
CD
LD-RF
aux.
DSS digital.
VCR
DSS
multi-room
tape
ON SCREEN MENU
ENTER
delaystatus balance
RM DIGITAL SOLUTION DR-1
COAX1
DIGITAL
STEREOTEST MEMO AUTO
PCM
power ———— standby
source
on/off
surround
multi-room
tune
save
preset
clear
presets
TUNED
OPT NIGHT
PROLOGIC
P-SCANSTEREO
MULTICOAX2
db
kHz
MHz
DOLBY
DIGITAL
RM DIGITAL SOLUTION
INTELLIGENT A/V PREAMP/PROCESSOR/LOUDSPEAKER SYSTEM
aux. inputs S-video
volume
video L..audio..R
Listening to the radio
1. Press the POWER switch (A) to turn on the power.
2. Press one of the SOURCE buttons (B) on the front panel, or the AM
or FM buttons on the remote (C) to select either the FM or AM band.
3. Press the TUNE UP and DOWN buttons (D) to tune in the desired
station. Pressing once for less than a half second changes the frequency
by one step. Pressing longer sequentially scans frequencies in the
indicated direction. Releasing the button in this state activates the auto
tuning function which automatically scans the frequencies until it
reaches a station, at which point the TUNED and signal level indicators
light and auto tuning stops.
4. Adjust the volume with the VOLUME control (E).
IMPORTANT NOTES ON FM RADIO RECEPTION:
The supplied FM antenna will only allow the tuner to pick up strong
local radio stations. If you want better reception of distant FM
stations you will need a better FM antenna. Your Polk Audio dealer
can recommend a high quality indoor or outdoor FM antenna. Be
sure to get one with a 75 Ohm coaxial output. If you already have a
TV roof antenna, you can use it for the FM tuner. Get a signal splitter
from a radio/TV dealer or Radio Shack store. It will allow you to use
the same antenna for TV and FM radio reception.
If a radio station you select has a lot of background noise or
otherwise sounds distorted, the tuner is not getting a strong
enough signal. Look at the Signal Strength indicator in the upper
left hand corner of the display. If there are three or fewer bars lit,
that means you need to point the antenna in a different direction.
Watch the signal strength meter as you slowly rotate the antenna,
noting which direction gives you the strongest reading on the
meter. If you still don’t get clear reception of the radio station, you
either need a better antenna, or the broadcast station is too far
away from your home for good reception.
HOW TO USE YOUR RM DIGITAL
SOLUTION SYSTEM
22