Filter
Top Products
12
PHASING (OR POLARITY)
It is important to achieve good stereo imaging in your listening room. By observing the wiring
instructions above, each power amplifier/loudspeaker combination should be in phase. If you experience
poor stereo image and/or a lack of bass, check that the loudspeaker wiring has been connected correctly.
We recommend that you use one of the easily obtainable ‘test discs’ to help you ensure both phasing and
channel orientation are correct. If in doubt, consult your PLINIUS dealer for advice.
Naturally it is also important to make sure all the leads carrying signals for the RIGHT channel loudspeaker
are connected to the RIGHT input to the amplifier from your preamplifier or CD player etc. Signals for the
LEFT channel should be wired in a similar fashion.
CONNECTING THE MAINS SUPPLY
Now that your Plinius P10 Power Amplifier is configured correctly, the mains cable can be plugged into
the IEC socket on the back of the amplifier. Turn on the power switch on the rear panel. The power LED
will cycle in brightness for approximately ten seconds as the internal circuitry stabilises. You can now
enjoy your new Plinius P10 Power Amplifier.
WARM-UP PERIOD
You will find that the Plinius P10 will become noticeably ‘purer’ in sound after being on for a period of
time. We usually recommend waiting at least 24 hours before expecting the best quality of sound
reproduction from your amplifier. Also, as the Plinius P10 uses very little power while on, we suggest
leaving the unit turned on so that it will always be at it’s sonic best.