Filter
Top Products
PAIRING
The Voyager 510 Bluetooth
®
Headset System is supplied with the Headset and Base
Unit factory paired to each other. However, if you have purchased a Voyager 510
System Base Unit or if you wish to use a replacement headset with your existing base
unit the units must be paired as follows:
1. Press and hold both the Speak Volume Adjust Buttons (3 & 4) on the base unit until
the indicator in the Call Control Button (5) starts to flash.
2. Press and hold the headset Listen Volume Adjust + Button (22) and headset Call
Control Button (21) until the Status Indicator (24) flashes red and blue.
3. Pairing completion is indicated when the Call Control Button indicator (5)
illuminates solidly, and the Status Indicator (24) flashes.
MAINTENANCE HINTS
1. Unplug the unit from the telephone and the AC Power Adapter from the mains
supply before cleaning.
2. To clean the headset, remove the headset from the attachment and wipe clean.
3. Clean the equipment with a damp (not wet) cloth.
4. Do not use solvents or other cleaning agents.
15