Filter
Top Products
ANSWERING A CALL
If the corded telephone is ringing press the Call Control button on the headset (A) or
on the base. (
B). If the mobile handset is ringing then press the call control button on
the headset (
A) to answer the call.
Note: If Intellistand
TM
is enabled the system will always activate the Handset Lifter.
To disable Intellistand
TM
please follow instructions on page 13.
PLACING A CALL
Placing a call on your corded telephone:
Lift the handset and then press either the Call Control button on the headset (A) or
base unit (
B). When you hear the dial tone, dial as normal. If you do not obtain a dial
tone, check that the Configuration Dial is set correctly as described on page 8.
Important: If your corded telephone has a receive volume control, ensure it is set no
higher than mid-range. Too high a setting could cause audio problems.
Placing a call on your mobile handset:
Dial using your telephone keypad or voice-dialling (if supported by your telephone).
Important: You will first need to pair the headset to your mobile handset. Refer to the
instructions on Pairing in the Voyager 510 Headset Quickstart Guide.
A B
A B
9