Pioneer XC-F10 Stereo Amplifier User Manual


 
38
9
Additional Information
Remote control doesn't work.
Try replacing the batteries.
Check that fluorescent light, or other strong light is not
shining onto the remote sensor.
Make sure that you're using the remote within its
operating range.
Can't record
Check that the erase-protect tabs are intact, or covered
with tape. Cover broken tabs with tape to enable recording.
(page 35)
Recordings are muddy or distorted
Clean the tape heads. (page 35)
Previous recording can still be heard
underneath a new one.
Check that you're using either a Type I (Normal), or Type
II (CrO2) tape.
Clean the heads. (page 35)
Playback sound is muddy or distorted; high
frequency sounds are excessively emphasized.
Check that Dolby NR is set to the same setting as that used
during recording. (page 27)
Miscellaneous problems
When the system is installed near a television set,
magnetic influence from the speakers may cause the
television’s picture to be distorted. This symptom
frequently occurs when using an indoor antenna; in this
event, install an outdoor antenna, or separate the system
farther from the television.
Static electricity and other outside electrical influences
may cause the system to operate incorrectly. In such cases,
unplugging and reconnecting the power cord may help
correct the problem.
More than one of the same kind of component (CD tuner,
MD recorder, CD recorder or cassette deck) cannot be
connected at the same time.
Troubleshooting
Incorrect use can be mistaken for trouble or malfunction. If
you think there is something wrong with this component,
check the points below. Sometimes the trouble may lie in
another component. Check the other components and
electrical appliances being used. If the trouble cannot be
rectified even after checking the points below, ask your nearest
Pioneer authorized service station to carry out repair work.
Power turns of suddenly during operation.
Check that the cooling vents are not blocked. Do not use
on thick carpet or cover with cloth in use.
No sound.
No sound when trying to listen to the radio.
Check that the FM and AM antennas are connected
properly.
CD doesn't play.
Check that the disc is loaded with its printed/label side face
up.
Check that the disc is clean and free of scratches and other
damage. If necessary, clean the disc.
When listening to the radio, the sound is noisy
or distorted.
If you're listening to a stereo FM station, try switching to
mono.
Check that the antenna(s) are connected securely.
Try moving the antenna(s) to face a different direction.
Check that there aren't any electrical appliances operating
near the antenna(s).
Try using the alternative tuning frequency interval.
Broadcast is stereo but the sound from the
speakers is mono.
Switch to auto stereo mode.
Can't set the timer.
Check that the clock has been set.