Filter
Top Products
Using the tuner07
36
En
Naming station presets
For easier identification, you can name your
station presets.
1 Choose the station preset you want to
name.
See Listening to station presets (this page) for
how to do this.
2 If you’re using the remote control,
press RECEIVER.
3 Press TUNER EDIT.
The display shows ST. NAME, then a blinking
cursor at the first character position.
4 Input the name you want.
Names can be up to four characters long.
• Use the MULTI JOG/INPUT SELECTOR dial
(front panel) or the STATION +/– buttons
(remote) to select characters.
• Press ENTER to confirm a character. If no
character is input, a space is input.
• The name is stored when ENTER is
pressed after choosing the fourth charac-
ter.
To erase a station name, simply repeat steps
1-3 and input four spaces instead of a
name.
Once you have named a station preset, you
can press DISPLAY when listening to a
station to switch the display between the
name and the frequency.
Listening to station presets
Having stored up to 30 stations (see previous
page), preset stations can be easily recalled.
1 Press TUNER (remote) or use the MULTI
JOG dial on the front panel to select the
tuner.
2 Press CLASS to select the class in which
the station is stored.
Press repeatedly to cycle through classes A, B
and C.
3 Press STATION +/– to select the station
preset you want.
• If the receiver is left disconnected from the
AC power outlet for an extended period,
the station memories will be lost and will
have to be reprogrammed.