Filter
Top Products
Playing sources05
26
En
Listening to multi-channel
playback
INPUT SELECTO
R
CD
T
V
/S
AT
DVD/LD
R
E
C
EIVE
R
C
D-R
/
VC
R
/
DVR
S
TANDAR
D
1 Switch on the playback component.
2 Switch on the receiver.
3 Select the source you want to playback.
Use the INPUT SELECTOR buttons on the
remote (or the MULTI JOG/INPUT
SELECTOR dial on the front panel).
4 Press STANDARD.
For multi-channel sources, Dolby/DTS decoding
is selected automatically according to the
source and shows in the display.
For a two channel source, you can press
STANDARD repeatedly to select the Pro Logic II
mode you want:
Pro Logic II
Music
Pro Logic
Pro Logic II Movie
Refer to page 24 for more details about each
mode.
5 Start playback of the component you
selected in step 1.
Using Advanced Surround
Dolby Pro Logic, Dolby Digital and DTS signal
processing is done automatically correspond-
ing to the input signal.
• Press ADVANCED SURROUND repeat-
edly to cycle the sound options.
Each press changes the display as follows:
Movie
Virtual SB*
Music
5-Stereo
Expanded
*VSX-D511 only.
Refer to page 24 for more details about each
surround effect.
• The Movie, Music, and Expanded effects of
Dolby/DTS can be adjusted in the range of
10 to 90 (the default setting is 70) by
pressing EFFECT +/– . The effect level can
be set for each of these Advanced
Surround mode. The Standard and Stereo
modes cannot be changed.
Using Loudness and Midnight
listening
The Loudness listening feature can be used to
get good bass and treble from music sources at
low volume levels.
The Midnight listening feature allows you to
hear effective surround sound of movies at low
volume levels. The effect automatically adjusts
according to the volume at which you’re
listening.