Filter
Top Products
Setting up
07
48
En
• Use
or
to set the distance of the
subwoofer from the main listening posi-
tion (within the range of 0.1 m to 9.0 m).
• When
SW NO
is selected in the
subwoofer setting, the subwoofer
distance can’t be set.
Dynamic range control setting
• Default setting:
OFF
Dynamic range is the difference between the
loudest and softest sounds in any given
signal. With this setting, you can compress
the dynamic range, so that low level sounds
can be heard more easily (sounding relatively
louder) yet louder sounds won’t be too over-
bearing.
• Use
or
to set the dynamic range
control (OFF, MAX, or MID).
• When listening at low volumes, set to
MAX
for maximum dynamic range
compression.
• Dynamic range control is effective only
when a Dolby Digital or DTS signal is
being played back.
Dual mono setting
• Default setting:
ch1
The dual mono setting can only be used when
listening to Dolby Digital and DTS signals
with dual mono encoding. It is sometimes
used when it is necessary to have one
language on one channel and a different
language on the other. With this setting you
can choose which channel in the dual mono
setting you want to listen to.
If Dolby Digital mode is switched on, you will
hear the channel you have selected (either
ch1
or
ch2
) through your center speaker. With
Dolby Digital mode off, or if you don’t have a
center speaker, you will hear the channel you
have selected through both front speakers. In
the
L ch 1.R ch2
setting, the left front speaker
will play channel 1 and the right front speaker
will play channel 2.
• Use
or
to cycle through the
possible dual mono settings.
Surround back channel input
setting
(VSX-D812/D912 only)
• Default setting:
SB 2ch IN
You only have to make this setting if you are
using a seperate component for decoding
DVDs, and the component has only one
surround back channel output. If this is the
case, select
SB 1ch IN
, otherwise leave it set
to
SB 2ch IN
.
• Use
or
to select SB 2ch IN or SB
1ch IN.
Digital input settings
Here you tell the receiver what components
you have hooked up to the coaxial and optical
DIGITAL IN
jacks on the back of the receiver.
After you assign a component to a digital jack,
whenever you select that component, (for
example, a DVD player) the receiver
automatically changes to the digital input
setting and
DIGITAL
shows in the display.
ch2
Lch 1.R ch2
ch1
VSX_712_812_912.book 48 ページ ２００３年２月６日 木曜日 午前１０時５１分