Filter
Top Products
5 minute guide
02
12
En
Using the Quick Setup
You can use the Quick Setup to get your
system up and running with just a few button
presses. The receiver automatically makes
the necessary settings after you have selected
your speaker setup, room size and listening
position.
Note that with the VSX-D912 you don’t have to
make these settings if you use the automatic
MCACC setup instead (in this case, go
straight to the
Quick surround sound setup
on
page 14).
If you want to make more specific settings,
refer to
Choosing your receiver setup
on
page 43.
Use the front panel controls for the steps
below.
1 If the receiver is off, press
STANDBY/ON to turn the power on.
The
STANDBY
indicator goes out.
2 Press QUICK SETUP.
SW DET
flashes in the display while the
receiver checks your setup for a subwoofer.
SW YES
or
SW NO
confirms the subwoofer
check, then the display prompts you to select
your speaker setup.
3 Use the MULTI JOG dial to choose your
speaker setup.
When a subwoofer was detected in step 2, you
can cycle between the following choices:
*
VSX-D812/D912 only
If a subwoofer wasn’t detected in step 2, you
can cycle between the following choices:
*
VSX-D812/D912 only
• Check the table below to find the speaker
setup that corresponds with your system.
*
VSX-D812/D912 only
DOWN UP
ENTER
MASTER VOLUME
MULTI JOG
R
SPEAKERS
S-VIDEO VIDEO L AUDIO R
A
DVANCED
S
URROUND
STEREO/
DIRECT
SIGNAL
SELECT
MIDNIGHT/
LOUDNESS
MONITOR TONE QUICK SETUP
VIDEO INPUT
ENING MODE
L DIMMER
MULTI JOG
DIGITAL IN
7.1ch*
4.1ch
6.1ch 5.1ch
2.1ch 3.1ch
7.0ch*
4.0ch
6.0ch 5.0ch
2.0ch 3.0ch
VSX_712_812_912.book 12 ページ ２００３年２月６日 木曜日 午前１０時５１分