Filter
Top Products
The System Setup menu
06
41
En
English
Français
Deutsch
Nederlands
Italiano
Español
Caution
• The test tones used in the System Setup
are output at high volume (the volume
increases to
–18 dB
automatically).
2 Use
/
to select each channel in turn
and adjust the levels
(
+/– 10 dB
)
as necessary.
Use
/
to adjust the volume of the selected
speaker to match the reference speaker. When
it sounds like both tones are the same volume,
press
(cursor down) to continue to the next
channel.
• For comparison purposes, the reference
speaker will change depending on which
speaker you select.
• If you want to go back and adjust a
channel, simply use
/
to select it.
3 When you’re finished, press RETURN.
You will return to the Manual MCACC setup
menu.
Fine Speaker Distance
• Default setting:
3 m
(all channels)
For proper sound depth and separation with
your system, it is necessary to add a slight bit
of delay to some speakers so that all sounds
will arrive at the listening position at the same
time. The following setting can help you make
detailed adjustments that you may not achieve
using the
Automatically setting up for surround
sound (MCACC)
on page 10.
1 Select ‘SP DISTN.’ from the Manual
MCACC setup menu.
2 Use
/
to adjust the distance of the
left channel from the listening position then
press
ENTER
.
3 Use
/
to select each channel in turn
and adjust the distance as necessary.
Use
/
to adjust the delay of the selected
speaker to match the reference speaker. The
delay is measured in terms of speaker distance
from
0.1
to
9.0
meters.
Listen to the reference speaker and use it to
measure the target channel. From the listening
position, face the two speakers with your arms
outstretched pointing at each speaker.
Try to make the two tones sound as if they are
arriving simultaneously at a position slightly
in front of you and between your arm span.
When it sounds like the delay settings are
matched up, press
(cursor down) to
confirm and continue to the next channel.
• For comparison purposes, the reference
speaker will change depending on which
speaker you select.
• If you want to go back and adjust a
channel, simply use
/
to select it.
4 When you’re finished, press RETURN.
You will return to the Manual MCACC setup
menu.
Acoustic Calibration EQ
Acoustic Calibration Equalization is a kind of
room equalizer for your speakers (excluding
the subwoofer). It works by measuring the
acoustic characteristics of your room and
neutralizing the ambient characteristics that
can color the original source material. This
provides a ‘flat’ equalization setting. If you’re
not satisfied with the automatic adjustment,
you can also adjust these settings manually to
get a frequency balance that suits your tastes.
Setting the Acoustic Calibration EQ
automatically
If you have already completed
Automatically
setting up for surround sound (MCACC)
on
page 10,
A. CH ADJ
and
F.ALG ADJ
(below)
should already be set. Therefore, if you want to
adjust your settings manually, you can skip to
Setting the Acoustic Calibration EQ manually
below.
VSX517_817.fm 41 ページ ２００７年２月２２日 木曜日 午後８時１１分